Before using conduit and superglue, ensure that the area is lightly sanded and free of any grease or dirt. Use the superglue sparingly and press hard on the conduit for 10 seconds as the glue works best with pressure. Apply a smear of glue to the groove in the conduit and firmly press in the tubing, again for a good 10 seconds.

Sections of conduit can also be used anywhere else on the frame or behind the footrest hangers to neatly route the delivery tubing on its way up to the reservoir on the sub frame.

On models with single sided swing arms, we also recommend removing the outer sleeve and metal rod and using the small dispenser plate. This can be mounted in a variety of ways, depending on the swing arm design – see model specific installation guides or contact us for advice and photos for different solutions.

When you’ve finish installing the dispenser, always rotate the rear wheel back and forth to ensure that the injector doesn’t snag on anything in either direction.